Canadian Electric Code {in Canada) installation Instruction 1.1 Installing the Receiver WARNING: TURN ELECTRICAL POWER OFF AT THE CIRCUIT BEAKER BEFORE BEGINNING THIS INSTALLATION. 1 Make sure the slide switch on the Remote Receiver is at the OFF position. See Figure 1. Remote Main Receiver Burner Millionth Generator Figure 1 Figure 2 2. Connect the leads to the millionth generator and the main burner to the output cable of the Remote Receiver as shown in Figure 2. 3.
8. Slide the battery compartment into the Remote Receiver. See Figure 5. 7. In order to prevent the Remote Receiver (fireplace installation only) from overheating, pul a heat shield {option tier} above the Remote Receiver. See Figure 6 1.2 Installing the Wall Mount Transmitter install the wall mount transmitter into a wall junction box. 2.0 Operation Instructions: 2.1 Transmitter Operation A. Flame On/Off 1. Press the Start button once to turn on the fireplace. 2.
blink. Press a button on the Remote Transmitter. The Remote Receiver will produce a ‘beep’ sound when it receives the code from the Remote Transmitter, if you do not hear a ‘beep’ sound from the Remote Receiver, removes batteries from the Remote Transmitter, wait for 1 minute, and repeat step 2 to 5. Replace the cover of the Remote Transmitter and the Receiver. The system is now ready fo operate.
