Instruction Manual

PROGRAM STEPS

MILLPWR

Operation Manual

Line

Lines are defined by their “From” point (the point where

they begin) and “To” point (the point where they end).

There are two ways you can program a line:

• With four coordinates (X1, Y1, X2, Y2)

• With three of the coordinates above (X1, X2, Y2 or X1,

Y1, X2, etc.) and an angle

Keep in mind that the angle is measured from the line on

the X-axis and sweeps towards the adjacent line.

Choose a method based upon the information available from

the print.

o program a line:

• Press the LINE key.

• Enter the beginning X- and/or Y-axes coordinates into the “From” field.

• Enter the ending X- and/or Y-axes coordinates into the “To” field.

• Enter a depth.

• If one of the X- or Y-axes fields above was left blank, enter an angle.

• Highlight the "Offset" field and press the

LEFT, CENTER, or RIGHT softkey.

• Enter the feed rate.

• Press the

USE key.

Note:

If the tool size and type listed in the "Tool" field are incorrect, change the tool

settings before running the program (refer to Programming a Tool Step).

5-7