Instruction Manual

PROGRAMMING

MILLPWR

Operation Manual

3-20

To create directories for your programs:

• Press the PGM key, the PROGRAM FUNCTIONS softkey and then the DIRECTORY

softkey. Now press the SELECT DIRECTORY softkey, and a directory list will

appear.

• Highlight the directory where you want to store the new subdirectory.

Select

MILLPWR's internal memory:

"MILLPWR" and any subdirectories should appear under the "Directory"

heading.

Select a 3

/2" floppy disk:

Press the

USE FLOPPY softkey. "A:" and any subdirectories should

appear under the "Directory" heading.

Select your PC:

Press the

REMOTE STORAGE softkey. "REMTSTOR" and any subdirec-

tories should appear under the "Directory" heading.

• Using the arrow keys, highlight the existing directory you want to put the new

subdirectory in. (In this example, we highlighted "MILLPWR," then created a sub-

directory entitled "COMPANY1.")

• Press the

SELECT DIRECTORY softkey again to verify your choice. The

"Directory" screen will disappear.

• Now press the

DIRECTORY softkey.

• Press the

CREATE DIRECTORY softkey. You will be asked to name your directory.

• Name your directory using the numeric keys on the operator console or by

selecting letters from the

ALPHABET option. Use the arrow keys to move from

letter to letter then press the

ENTER key to make a selection. Program names are

limited to eight characters, consisting of numbers and/or letters.

The REMOTE

STORAGE soft-

key will only

appear if

MILLPWR has

been set up for

remote storage.