Instruction Manual

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-20
• Enter the feed rate.
• If you want to program a finish cut, press
the
MORE softkey. Otherwise, press the
USE key.
Finish
Enter the amount of material to be
removed during the finish cut.
Enter the feed rate for the finish cut.
Select the finish cut’s direction. Press the
CW softkey for a clockwise
direction or the
CCW softkey for a counter-clockwise direction.
Enter a stepover percentage (how much you want the tool to overlap on
each pass).
Press the
USE key.
Note:
If the tool size and type listed in the "Tool" field are incorrect,
change the tool settings before running the program (refer to
Programming a Tool Step).