User guide

22
MICRO-LINE Reference Manual
OPERATION
4. Press the X key. Using the keypad,
define the center point of the bolthole
pattern on the X-axis. Use a decimal
point and minus (-) sign when neces-
sary.
5. Press
ENTER.
Creating a Bolthole Pattern
A bolthole pattern is defined by its
number of holes (up to 99), center
point, radius, and start angle.
MICRO-LINE will automatically posi-
tion “Hole 1” at the start angle and
space the holes equally throughout the
pattern.
To create a bolthole pattern:
Bolthole Patterns
1. Press the BOLT DEF key. "HOLES"
will appear on the X-axis display.
2. Enter the number of holes (1-99) in the
pattern. Press the
ENTER key.
3. Press the
ENTER key again. “Center”
will appear, and then a flashing dash will
appear on the X- and Y-axes.
Hole 1
MLMmanual.QXD 2/12/02 5:01 PM Page 47