User`s manual

ii
Soft Key function (Page 2) Soft key
Opens the Datum form to set the datum for each axis
(
page 27).
Opens the Preset form. This form is used to set a
nominal position. This is a Distance-To-Go
(Incremental) function (
page 32).
Used to divide the current position by two (
page 35).
Press to select the Circle Pattern, Linear Pattern,
Incline Mill, or Arc Mill table (
page 37).
Soft Key function (Page 3) Soft key
Opens the Job Setup menu and provides access to
the Installation Setup soft key (
page 13).
Press when ready to identify a reference mark (
page
11
).
Opens the Calculator functions for standard math,
trigonometry, RPM, and Taper for Turning functions.
The
CALC key is also available on input forms
where calculations may be required while
inputting data.
Toggles between inch and millimeter units (page
13
).