Specifications

Please follow these preparation guide lines.

• Understand your mounting requirements.

• Mount with lip seals down and away from the work area.

• Brackets should be kept as short as possible and rigid.

• Surfaces must be in good condition, clean, and free of dirt. Remove

paint from machined mounting surfaces.

• Alignment brackets must not be removed until

instructed.

• Machine travel can not exceed the encoder measuring length.

• Either limit machine travel or obtain correct length scale.

• Never mount with lip seals upward or towards work area.

3 ACU-RITE

ENC150 Mounting Preparation

“L” = Measuring length + 1.75” nominal over travel

“L”

1.150

Cable direction

• Determine the cable exit direction before installing the encoder.

• To change the cable exit direction; remove the cover plate and

rotate the cable 180°.

T-10 Torx screw (2)

Plug

Cover plate

Vinyl cable grommet

Armor cable hex crimp