Specifications

• Drill / tap the first end mounting hole / attach the linear encoder.

• Align to within .010” TIR. to -A-, drill / tap second end hole.

• Attach the linear encoder / align to within .010” TIR. to -A-.

• Center the axis and mark the reading head mounting holes.

• Move axis, drill / tap holes for 8-32 (M4).

• Attach head to axis / Set leveling screws / Secure fasteners.

• Use the center support(s) when provided.

• Place supports at equal intervals along the encoder’s length.

Center support

1/4-20 x 1” BHCS & Scale flat washer (M6 x 25mm)

Align to within .010” TIR to -A-

Drill / tap

for 1/4-20 (M6).

8-32 x 3/4” SHCS

(M4 x 20mm)

Drill / tap for 8-32 (M4)

ACU-RITE

Encoder Installation Procedure ENC 150

1/4-20 x 3/4” SHCS

(M4 x 20mm)

-A- = Axis travel

-A-

Flat washer (M6)

Do not tighten prior to adjusting leveling set screws

• Slide the brackets away from the reading head.

• Remove the alignment brackets and save for future use.

• Proceed to page 13, “Checking Your Installation”.

Alignment bracket removal

Slide brackets away from reading head and cable.

Twist 45°