Data Sheet

Wiring Diagram:
Important Notes:
The ‘-S’ series linear actuators from Firgelli Technologies Inc. have limit switches at both ends of stroke to
turn off the actuator once it has reached the limit. The remote control will not turn off the power, so if
the actuator is not allowed to reach its full stroke, i.e. it stalls, it will continue to draw power, possibly
draining your battery and burning out the actuator. You should test your application to ensure that the
actuator is reaching its limit switches at each end of the stroke.
Programming Remotes:
If your remote loses it’s programming, or you purchase a spare or replacement remote, you will need to
program it to work with your remote control unit. Remove the cover of the remote receiver unit with a
phillips screwdriver to access the learning button shown in picture below.
1. Learning New Codes: Press and release the learning button, the red LED will light up. Within 5
seconds press one button on the remote, the red LED should go out indicating the remote is
successfully programmed. Repeat this procedure for other remotes. The receiver unit can accept up
to 40 remotes.
2.
Erasing Codes: Press and hold the learning button for 5 seconds, the red LED will flash 5 times,
signaling all stored remote codes have been successfully cleared.
Copyright 2013

Firgelli Technologies Inc.