Data Sheet

ManualsBrandsActuonix ManualsGeneral RFWireless Remote Controller for 12V Actuators

Applications

→ Home Automation

→ Hobby Applications

→ Automotive

Control Accessories · REMOTE CONTROL

Firgelli Technologies’ unique line of Miniature Linear Actuators just became easier

to control with our new 2 channel remotes. This remote control unit is perfect for

controlling any of our 2-wire ‘-S’ series actuators. Each kit comes with two 2-

button remotes which control the actuator to move up or down. The remote kit is

designed for use in home automation, automotive and hobby applications where

DC power is available and remote control is required. This remote control is NOT

compatible with hobby type Radio Control (RC) equipment, or our ‘–R’ actuators.

Remote Control Specifications

Input Voltage 12VDC (8V min. 14V max.)

Switched Current

Standby Current

6 Amps Max.

50mA

Operating Temperature

-20°C to +60°C

Range 100 meters

Dimensions (Receiver) 70mm x 55mm x 30mm

Dimensions (Remote) 62mm x 32mm x 12mm

Frequency 422.92 MHz

Remote Batteries 2x CR2016 (3v Coin Cell) included

Compatible Actuators L12, L16, P16, T16 –S 12 Volt

PQ12 –S 12 Volt (requires cable adapter)

Wiring

Firgelli’s Remote Control is extremely easy to install and operate. Simply

plug in your Firgelli actuator to the red and black wire from the remote

control unit. (PQ12-S actuators will require a cable adapter, not included)

Connect your fused 12 volt power source to the black and black with white

stripe wires using 1/8” spade crimp connectors or by cutting and splicing

the wires. The black with white striped wire is positive 12 volts. The black

wire is negative. The third short black wire is the antenna and should be

left unconnected. Straighten or extend this wire to improve the range.

Secure your remote base unit using double sided tape or two screws

through the mounting holes (not provided). Multiple actuators may be

wired in parallel to one remote control device, however the total current

draw for all the actuators must not exceed the remote units current rating

and should not exceed your power supply’s current rating.

Operation

Apply 12 volt power to the unit. Press the “UP” button on the remote and

the actuator should extend fully. Press the “DN” button to retract.

Pressing either button again while the actuator is moving will stop the

actuator. Pressing the opposite button while the actuator is moving will

reverse the actuators direction. A blue LED should light each time the

buttons are pressed to indicate it is functioning.



Firgelli Technologies Inc.

Summary of content (2 pages)

PAGE 1
Control Accessories · REMOTE CONTROL Firgelli Technologies’ unique line of Miniature Linear Actuators just became easier to control with our new 2 channel remotes. This remote control unit is perfect for controlling any of our 2-wire ‘-S’ series actuators. Each kit comes with two 2button remotes which control the actuator to move up or down. The remote kit is designed for use in home automation, automotive and hobby applications where DC power is available and remote control is required.
PAGE 2
Wiring Diagram: Important Notes: The ‘-S’ series linear actuators from Firgelli Technologies Inc. have limit switches at both ends of stroke to turn off the actuator once it has reached the limit. The remote control will not turn off the power, so if the actuator is not allowed to reach its full stroke, i.e. it stalls, it will continue to draw power, possibly draining your battery and burning out the actuator.