User Manual

en
|
58
|
User guide
|
CP9690 Elite AutoScanner®
573464 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
STAR Test Mode
ENTER to hold
Test/Hold On: Test
54
• With the STI in the TEST state, the self-test
begins. A beep accompanies each time STO is
low. When a completed 2-digit or 3-digit code is
received, it is shown on the display. Write down
the 2-digit or 3-digit code for reference.
• If necessary, refer to the appropriate service
manual for procedure on how to use STAR Test
Mode for the specific vehicle under test.
3. Return to On Demand Tests Menu.
• Press .
8 Chrysler OBD I Diagnostics
8.1 Diagnostic Menu
IMPORTANT
Review Data, Print Data, Code Lookup, Acro-
nyms and System Setup are covered in Section
5 of this manual. These items are not covered in
this section.
The Chrysler Function List is broken down into the
following selections:
• Datastream
– View Data
– Record Data
– Acronyms
– Review Data
– Print Data
– Code Lookup
– System Setup
• Diagnostic Codes
– Read Codes
– Erase Codes
– Acronyms
– Review Data
– Print Data
– Code Lookup
– System Setup
• Acronyms
• Review Data
• Print Data
• Code Lookup
• System Setup
If an Error Message displays, make sure the adapter
cable is securely attached and the ignition key is on.
Cycle the ignition key to off for 10 seconds, then on.
This may be required to reset the computer. If required,
select yes to try again. If the problem still exists, refer to
”10.1 Error Messages” on page 61. Screens and
functions may differ slightly for vehicle make and year.
8.2 View Data
The View Data function allows the user to view the
vehicle Parameter Identification (PID) Data in real time.
As the powertrain control module (PCM) monitors PIDs,
they are simultaneously transmitted to the scan tool. The
PIDs are continuously updated at the PCMs rate.
In addition to reading codes, View Data is the most
useful diagnostic function for isolating the cause of a
vehicle operation problem. Viewing data is also used for
observing sensor data and the ON/OFF state of
switches, solenoids, and relays.
View Data can be performed with the ignition key on-
engine off (KOEO) or key on engine running (KOER).
CAUTION
Two people must be in vehicle when driving.
One to drive and the other to operate the
scan tool.
From Datastream Menu:
1. Select View Data.
• Use the UP and DOWN keys until View
Data is highlighted.
• Press .
Datastream
View Data
Record Data
Acronyms
Review Data
Print Data
Code Lookup
System Setup
CAUTION
Keep hands and tools away from fan and
engine during test.
On 1999 and newer vehicles, a screen may ask you to
select engine data or transmission data.
Some vehicles display a Select Group screen for viewing
data. In these cases, only one group of data can be
viewed at a time.
Select Category
Switches
Sensors
Engine
2. Select the type of data to view.