User Guide
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Diagnostic Menu
- 5.1 I/M Monitors (Emissions)
- 5.2 Read Codes
- 5.3 Erase Codes
- 5.4 MIL Status
- 5.5 State OBD Check
- 5.6 View Data
- 5.7 Record Data
- 5.8 View Freeze Data
- 5.9 Drive Cycle Monitor
- 5.10 O2 Monitor Tests
- 5.11 Diagnostic Monitor Tests
- 5.12 On-Board Systems
- 5.13 Vehicle Information
- 5.14 Oil Light Reset
- 5.15 Battery Reset
- 5.16 Charging System Monitor
- 5.17 Modules Present
- 6 Troubleshooting
- 7 Appendix A— PID Definitions
- 8 Appendix B—Glossary
- 9 Limited Warranty
en
|
2
|
User guide
| CP9680
AutoScanner® Plus
573102 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
Serial No: __________________________________
SW ID: _____________________________________
HW Ver: ____________________________________
Boot Ver: ___________________________________
Prod ID: ____________________________________
Board ID: ___________________________________
Burn Date: _________________________________
Record the above information about your tool. The information is available
at Main Menu --> System Setup --> Tool Information. Provide this informa-
tion when contacting technical support.
If you have questions or concerns contact Technical Support:
Phone: 800-228-7667
E-mail: tech@actron.com
The information, specifications and illustrations in this guide are based on
the latest information available. Bosch reserves the right to make changes
at any time without notice.