User Guide
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Diagnostic Menu
- 5.1 I/M Monitors (Emissions)
- 5.2 Read Codes
- 5.3 Erase Codes
- 5.4 MIL Status
- 5.5 State OBD Check
- 5.6 View Data
- 5.7 Record Data
- 5.8 View Freeze Data
- 5.9 Drive Cycle Monitor
- 5.10 O2 Monitor Tests
- 5.11 Diagnostic Monitor Tests
- 5.12 On-Board Systems
- 5.13 Vehicle Information
- 5.14 Oil Light Reset
- 5.15 Battery Reset
- 5.16 Charging System Monitor
- 5.17 Modules Present
- 6 Troubleshooting
- 7 Appendix A— PID Definitions
- 8 Appendix B—Glossary
- 9 Limited Warranty
573102 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
CP9680
AutoScanner® Plus
|
User guide | 15
|
en
System Setup
English/Metric
Auto-Power Off
Quick Test
Print Header
Language Setup
Long PID Names
Pre-Trigger Setup
Tool Information
Display Test
2. Start Display Test.
• Press .
3. Look for missing spots.
• The first screen displayed says, “Check for
missing spots in the display.”
Display Test
Press BACK to exit
Check for spots in the
display
• Solid red, green, and blue screens are displayed.
• These four screens will continue in succession
until is pressed.
4. Press to exit the test and return to the System
Setup menu.
Keypad Test
The Keypad Test is used to verify that the keys are work-
ing correctly.
From System Setup screen:
1. Select Keypad Test.
• Use the UP and DOWN keys until Keypad
Test is highlighted.
• Press .