Instructions Manual

Using the Tool
3-9
F Press BACK key on Scan Tool to return
to Main Menu.
3.6 Tool Setup/Test
The Tool Setup/Test functions allow
the user to adjust the display’s
contrast and perform self-tests.
3.6.1 Changing Display Contrast
The contrast is displayed as a percent value ranging from 100% to
5% and can be changed by 5% intervals .
In the Tool Setup/Test menu, the
first function is Adjust Contrast.
Press the ENTER key and then use
the
▲ or ▼ keys to increase or
decrease the contrast. Holding
down the
▲ or ▼ keys changes the contrast in that direction in 5%
steps. When done, press the ENTER key to return to the Tool
Setup/Test menu.
Contrast settings are not saved after the tool is turned OFF. Contrast
is reset to the manufacturers setting when powered-up.
To quickly change the contrast after powering the AutoScanner,
press the ▼ key four (4) times and then the ENTER key twice.
READ
ERA SE
NO
BACK
ENTER
YES
Main Menu
5)Tool Setup/Test \
\] Change
90% ENTER When Done
!