Owner manual

Step 4
AttachtheTableBed(EP-1140)totheA-frame(F7-1002)
• Holding each side near the Roller Hinges, pick up the Table Bed and stand at the front of the A-frame where the
Crossbar is located. Lower each Pivot Pin into the A-frame hinge plates one at a time (Figure 7). You may need
to push outward on the A-frame in order to slide the second Pivot Pin into the hinge. Figure 8 shows the correct
placement of the Pivot Pin into the hinge plate.
• Make sure that both Pivot Pins are seated at the base of the slot in the hinge plate. Check to make sure that the
self-locking hooks have closed over both Pivot Pins, and the table rotates smoothly (Figure 9).
Figure 9
Figure 7
Figure 8