Owner manual

Step 1
AssembletheA-frameBase(F7-1002)andInstalltheHandles(F5-1069)
• Open the A-frame and make sure the spreader arms are locked, rest the A-frame on the oor (Figure 1). The
Crossbar is at the front.
•
Place each Hand Grip (left/right) over the outside edge of the
corresponding Hinge Plate (Figure 2).
• Insert three 1/2” (13mm) hex bolts (H1-1202) through the hinge plate into each Hand Grip. Use the wrenches
provided to tighten the bolts, being careful not to over-tighten.
Figure 2
Figure 1
spreader arms
front
back
Crossbar
Right
Left