User guide

14
EverGo User Manual
Figure 9. Touch the number to change the
flow setting.
4. Tosetthedevicesowsetting,
rsttouchthelargenumber(such
asthe2showninFigure9)inthe
center of the screen.
5. Eachtimeyoupresstheow
settingnumber,anuparrow
and/ordownarrow
willappearonthescreen.
(ExamplesareshowninFigures16-17).Toincreasetheow
setting,presstheuparrow.Todecreasetheowsetting,pressthe
downarrow.
edevicecanbesetto:1,1½,2,2½,3,3½,4,4½,5,5½,and6.
Warning: It is very important to set your device to your prescribed level
of oxygen flow. Do not increase or decrease your flow rate from your
prescribed level until you first consult with your physician.
Note: When it is turned on, the device will automatically start at the flow
rate setting used when the device was last turned off. As a precaution, each
time you start the unit, verify the flow setting.
6. Positionthenasalcannulaonyourface,asshownbelow,and
breathe normally through your nose.
Figure 10. Correct position of cannula on your face.
www.ActiveForever.com