User guide

EverGo User Manual

Note: An optional EverGo Smart Battery Charger/Recalibrator (sold

separately) is available for your system. For more information, contact

your home care provider.

op e r a T I n G T h e ev e r Go de v I C e

Warning: Do not use the device without one battery installed and operating.

• Torunthedeviceonbatterypower,makesurethebatteryis

properlyinsertedandsucientlycharged.(ebattery(s)shouldbe

fullychargedthersttimeyouuseit.)

• TorunthedeviceusingACpower,makesureyouhaveonebattery

installed.Followthesesteps:

1. ConnecttheoutputcableoftheACPowerSupplytothe

EverGopowerinlet.

2. ConnecttheconnectoroftheACPowerCordintotheAC

powersupply.

3. ConnecttheplugoftheACPowerCordintoanACoutlet

installed to meet national or regional electrical code.

Note: e AC Power Supply is equipped with a green light, which

illuminates when it is connected to an energized AC power source.

• TorunthedeviceusingDCpowerfromanautomobileorother

motorizedvehicle,makesureyouhaveonebatteryinstalled.

StartthevehicleandconnectoneendoftheDCPowerCordto

thedevice’spowerinletandtheotherendintothevehicle’sDC

electrical outlet.

Caution: If you operate the EverGo system using the DC power cord

while the vehicle engine is turned oﬀ, you could inadvertently drain

the vehicle’s battery.