User guide

EverGo User Manual

Charging the Battery(s) with AC Power Supply

Important: e ﬁrst time you charge the battery(s), be sure to charge it fully. Do

not use the DC power cord to do so; instead use AC power.

Note: e battery(s) will begin charging whenever you connect the device to an

AC outlet, even if you’re using it.

Tochargethebattery(s)usingtheACPowerCordprovidedwithyoursystem,

followthesesteps.

1. ConnecttheoutputcableoftheACPowerSupplytotheEverGo

powerinlet.

2. ConnecttheconnectoroftheACPowerCordintotheACpower

supply.

3. ConnecttheplugoftheACPowerCordintoanACoutletinstalled

to meet national or regional electrical code.

Figure 6. Connecting the power cord to the connector located under the Velcro ﬂap.

A typical battery charging screen is shown on the right

Note: As soon as you connect the device to an energized AC power

source, the light on the AC Power Supply will light up and the cooling

fan will come on. is is normal. e fan will run the entire time it is

charging to keep the battery(s) cool.

4. Whenchargingiscomplete(thistakesaminimumoffourhours

forrstuse),disconnecttheACPowerSupplyandstoreitwiththe

ACPowerCordforfutureVTF

VER 1.0.0.0