User guide

8
EverGo User Manual
Inserting the Battery(s)
YourEverGodevicecomeswithoneortwolithiumionbatteries.Toinsertthe
battery(s)correctly,followthesesteps.
1. Placeyourdeviceinawellventilatedlocation.
Note: e EverGo device is shipped from the factory with the battery(s)
removed.
Caution: Open the carrying case only when EverGo is turned off.
Never open the case while the unit is operating.
2. Open the top of the carrying
caseusingthezipper
located underneath the
flap surrounding the top
partofthecase,asshown
here. If the device has been
operating, the surfaces
insidemaybewarmtothe
touch. is is normal.
3. Checkthefuelgaugefor
thebattery(s).Todoso,
pressthewhitedotonthebattery(s)andwatchhowmanyLEDs
lightup.Ifthebatteryislow,youcanrechargeit.Seethenext
section of this manual.
No� of LEDs Battery Charge
4 LEDs Light:
75% to 100% full
3 LEDs Light:
50% to 75% full
2 LEDs Light:
25% to 50% full
1 LED Lights:
10% to 25% full
1 LED Blinks
3 Times:
Battery is less than
10% full and
needs to be
recharged
Figure 2. Battery Fuel Gauge
and White Button
Figure 1. Opening the carrying case
Table 2. Battery Charge Level
www.ActiveForever.com