User guide

SECTION 6—OPERATING INSTRUCTIONS
Invacare SOLO
2
™ 26 Part No 1156872
Breath Detect Indication
(PulseModeOnly)TheGREENindicatorlightwillblinkoffeachtimean
inhalationisdetectedandthetransportableoxygenconcentrator outputsa
measuredpulseofoxygen.
Audible Alarm
Thetransportableoxygenconcentr atorisequipped withanaudiblealarm.
Theaudiblealarmwillactivatedinconj unctionwith IndicatorsandLCD
Displayto
annunciateAlarmsandWarnings.
Thetransportableoxygenconcentr atorwillalsoissueasteadybeepwhen
allpowersourcesareremoved.Thebeepingwillstopafter10‐20minutesor
onceapo wersourceisconnected.
Thetransportableoxygenconcentr atorwillbrieflyturnonallthreelights
andtheLCDdisplayand
checkforstuckbuttonsuponpow erup.Itwill
thenoutputabriefaudiblebeeptoindicate theunitisoperational.
Control/Adjustment Buttons
TherearefourbuttonslocatedsurroundingtheLCDdisplay.Theyareused
toturntheuniton/off,toproceedtothenextscreen,toselectandhighlight
adjustablesettingsandtoadjustthosesettings.
On/Off Button
Toturnthetransportableoxygenconcentratoronoroff,pressandholdthe
On/Offbuttonfora
periodof2‐3seconds,nottoexceed5seconds.Releasing
thebuttontoosoonwillnotallowtheunittodo either.Ifthebuttonisheld
toolongwhenturningontheunit,theStuckButtonalarmcouldbe
activated.
Mode/Return/Highlight Button
Pressingbuttonfor1‐2secondsin the
Standbyscreen(FIGURE6.5on
page 27)willswitchtoNormalOperatingscreen(FIGURE6.6on page 27).
Pressingthisbuttonfor1secondintheNormalOperatingscreenwilltoggle
betweenthe continuousandpulsemodes.
Pressingthisbuttonfor2‐3secondsintheNormalOperatingscreenwill
displaytheLCD
Adjustments creen.In theLCDAdjustmentscreen
pressingthisbuttonfor1secondwillswitchcolumnsonthescreen.Tosave
changesandexittheLCDadjustmentscreenthehighlightbarneedsto be
positionedintheleftcolumn,thenpressthisbuttonfor2‐3secondstoretur n
to
theNormalOperatingscreen.Ifthescreenswitcheswithou tpressingand
holdingthebuttonfor2‐3secondsthechangesmadeintheLCD
Adjustmentscreenwillnotbesaved.
Increase and Decrease Buttons
Whenthehi ghlightbarisonthesettingname,thesebuttonsareusedto
selectthenextsettinginthelist.
Whenthehighlightba r isonthesetting
value,thesebuttonswillchange thevaluetothenextvalueavailable.