SUPERIOR SERIES LIFTS TABLE OF CONTENTS 1. New Construction Sleeve Anchor System 2. Retro Fit Sleeve Anchor Method active forever.
SUPERIOR SERIES LIFTS S-350 NEW CONSTRUCTION & SAW CUT SLEEVE ANCHORING METHOD INSTALLATION MANUAL
SUPERIOR SERIES S-350 SLEEVE ANCHORING SYSTEM INSTALLATION PARTS LIST 1 - Anchor Sleeve w/ Base 1 - Bonding Lug w/ nut & bolt 1 - Plastic Cap
ANCHORING SLEEVE, BASE PLATE & BONDING LUG S-350
ADA GUIDELINES FOR POOL LIFT PLACEMENT •Pool Lift Location. Pool lifts shall be located where the water level does not exceed 48 inches (1220 mm). Seat Location. In the raised position, the centerline of the seat shall be located over the deck and 16 inches (405 mm) minimum from the edge of the pool. The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. •Clear Deck Space.
SUPERIOR SERIES – SLEEVE ANCHORING SYSTEM Water Pool Wall 12” to 17” Distance From Water’s Edge (front edge of anchor sleeve) Actual application Overview 3’ Anchor Sleeve Section Detail 3’ 3’ Cold Pin Concrete Anchor Sleeve 6” Cold Pin Concrete Bonding Lug COMPACT SAND Front of Anchor Sleeve must be 12” to 17” from the water’s edge Optimal placement is 14” Connect copper wire to the bonding lug and then to your bonding grid Cold Pin’s should be ½” rebar 6” to 8” long NOTE: Make sure your anc
Step 1: Determine the location for installation (Make sure all ADA requirements are met). ***NOTE: The installation of Global Lift Corp’s anchor system’s are a guideline of minimum requirements. In some states or municipalities they may require additional steps due to their local codes or ordinances.
Step 5: Place the Anchor Sleeve in the cut out area, make sure that the front of the Anchor Sleeve is 12” to 17” from the water’s edge. (refer to overview) A key element is to make sure that the Anchor Sleeve is level and square with the pool so that your Superior Series Lift sits properly on the deck. Step 6: Bonding the unit – The bonding lug is supplied with the Anchor Sleeve locate the bonding lug, connect the bonding lug to the bonding grid. NOTE: Make sure that all local codes and ordinances are met.
