Owner manual

2524
Chapter 7 troubleshooting
Chapter 7 troubleshooting
• No power to the unit
• Can you power the unit using the included AC
adaptor? (pages 10-11)
• Is the power supply properly connected to a surge
protector or an AC outlet (mains)? (page 10)
• Are the correct batteries being used and do they
need to be charged or replaced? (page 18-20)
• Are the batteries inserted correctly? (page 19)
• Video image on LCD is blurry or not clear
• Clean the LCD display and/or camera lens using
the included cleaning cloth.
• Adjust the distance of the Pebble from your
reading material or adjust the handle angle as
needed to improve image quality (focus)
• Try selecting different viewing modes to improve
image quality (page 12)
• Video image on LCD display is too bright/dark
• The Pebble is designed to be used in moderate
lighting conditions, preferably indoors. Bright
lighting (or direct sunlight) may produce shadows
and/or reduce visibility. Try moving to a more
shaded area to improve image quality.
• Adjust the distance of the Pebble from your
reading material or adjust the angle of the handle
as needed to improve image quality (focus)
• Try selecting different viewing modes to improve
image quality (page 12)
• Try adjusting the LCD brightness manually using
the procedure described (page 14).
• Batteries will not charge
• Can you power the unit using the included AC
adaptor? (pages 10-11)
• Is the power supply properly connected to a
surge protector or AC mains? (page 10)
• Are the correct batteries being used and do they
need to be charged or replaced? (page 18-20)
• Are the batteries inserted correctly? (page 19)
• Are you using rechargeable batteries? (page 18)
• Unit turns off automatically
• To conserve power, your Pebble will
automatically turn off the LCD after 3 minutes of
non-use. This is not a malfunction.
• Are the correct batteries being used and do they
need to be charged or replaced? (page 18-20)
• Pebble begins to make a “beeping” sound
When battery is getting low the unit will start
beeping every 13 seconds. The beeping rate will
increase every minute until it beeps at a maximum
warning rate of once every 3 seconds. Pebble will
turn off about 15 minutes from the time it starts
beeping. It is recommended to charge the battery
when the unit starts beeping. (page 20)
• Pebble is displaying “Charge Battery”
10 minutes after the beeping starts a CHARGE
BATTERY warning will show on screen for 4
seconds in intervals of every 15 seconds. It is
recomended you charge your Pebble immediatley
or it will shut off.
• Unit becomes warm to the touch
Your Pebble integrates a camera, LCD and battery
charging unit inside a small very package, but is
designed to be completely safe and does not pose
a risk of re or damage. It is normal for the Pebble
to become warm (sometimes, very warm) after ex-
tended periods of use. However, this is completely
normal and does not indicate a malfunction.
TROUBLESHOOTING