User's Manual

User’s Guide
16
FILLING THE SPA
1. Ensure that the power pack is not plugged in.
2. Remove the protective caps from
the suction and discharge fittings
inside the spa. Place the caps in a safe
location.
3. Using a garden hose, fill the spa
with approximately 1/2 inch
of water. STOP! With hands,
smooth out any wrinkles on
bottom of liner, starting from the
center of liner and proceeding
outwards towards the wall.
Continue filling the spa with water
to two inches above the top of the
suction fitting.
Be careful not to over fill the spa,
or the spa may overflow during
use. Each average adult will
raise the water level in the spa
approximately two inches, and the
turbo wave blower action will raise
water level an additional three to
four inches.
Approximate
Fill Line