Owner`s manual

Step 2
EP-560, EP-560 Sport & EP-560 Limited Models
Depending on the model you have purchased, the items in this step will vary.
See “Which Model Do you Own?” (page 4) for more information.
Assemble the Handles to the Table Bed (EP-1300)
Bolts/Nuts may come pre-assembled in the Handles. Simply unscrew to remove.
EP-560 models: Assemble the Stretch Assist Handles (E6-1500)
• Place each Handle (left / right) over the outside edge of the corresponding Hinge Plate.
The handles are stamped with an “L” for Left and an “R” for Right, this can be found on the
interior of the handle (Figure 4).
• Insert three Allen Head Bolts ((F5-0071) through the Hinge Plate into each Handle (Figure
4A). Tighten with the Allen Wrench provided, being careful not to overtighten.
FIGURE 4
FIGURE 4A