Owner`s manual

Maintenance
• To clean the Inversion Table, wipe down with a damp cloth. Do not use abrasive
cleaners or solvents.
Storage
• Remove the Angle Tether from the U-Bar located on the underside of the Table Bed.
• Pull the Height-Selector Locking Pin and slide the Main Shaft in all the way to the
last hole setting.
• Release and engage the Pin in the storage setting.
• Rotate the Table Bed opposite from use until it has turned 180° and rests against
the Crossbar of the A-Frame.
• Pull up on the Spreader Arms to fold the A-Frame (Figure 29), leaving the A-Frame
legs open to a width of 12” for stability.
NOTE: This operation may pinch fingers if not done slowly and carefully.
Maintenance/ Storage
Tipping Hazard: For upright storage, leave A-frame open wide
enough to remain stable, or secure to the wall to prevent tipping.
In households with small children, the inversion table should be stored
at on the oor, not upright.
WARNING
!
FIGURE 29