Owner`s manual

Step 5
Depending on the model you have purchased, the items in this step will vary.
See “Which Model Do you Own?” (page 4) for more information.
Assemble the Roller Hinges to the Table Bed (EP-1300)
EP-560, EP-560 Ltd. & EP-860: Use 3-Hole Roller Hinges (F5-1064)
EP-560 Sport, EP-950 & EP-970: Use 3-Hole Roller Hinges with Traction Handles (TR-
1003)
• For ease-of-assembly, rest the Table Bed against the Crossbar (Figure 15).
• Open the Cam Locks on each side of the Table Bed (Figure 16).
• With the Pivot Pins facing outward, insert the Roller Hinges into the brackets on each side
of the Table Bed Assembly. The Roller Hinges must slide between the Cam Locks and the
Brackets (Figure 16).
• Engage one of the holes in the Roller Hinge over the Bracket Pin. Make sure the Roller
Hinges are in the same hole setting on both sides. Figure 17 shows the Roller Hinges
engaged correctly, with the Bracket Pin engaged in Setting C.
• Push down on the Cam Locks (Figure 18) to secure the Roller Hinges.
NOTE: Refer to the Owner’s Manual for an explanation of the hole settings.
If you are unsure, use Setting C to start.
Cam Lock
2
Pivot Pin
1
1
2
Unlocked
Locked
CBA
FIGURE 15
FIGURE 16
FIGURE 17
FIGURE 18
Bracket Pin
1
1
WARNING
!
NEVER disassemble the Roller Hinge.