Owner`s manual

Step 3

Install the Front Ankle Bar Assembly

• With hole settings facing up, insert the Front Ankle Bar (EP-1045B) into the Front Ankle Bar

Housing (Figure 10). Pull up on the T-Pin Lock to allow the Front Ankle Bar to insert all the

way into the housing. Release the T-Pin to engage in the hole setting closest to the Front

Ankle Cups.

• From the reverse side, pull on the zip-tie to stretch the Retainer Spring and Cable Loop so

that they align with the holes in the back of the Front Ankle Bar Housing (Figure 11).

• Insert the Bolt (F5-1089) starting through the outer side of the housing in the following order:

hole, Retainer Spring and Cable Loop, hole (Figure 11).

• Tighten the Nut (H1-3007) using the 13mm Open Wrench (F5-1088) provided.

• Cut the long portion of the zip-tie with scissors (Figure 11A) so that it doesn’t interfere with

the function of the Retainer Spring. Cover the open end with the End Cap (F5-1048)

(Figure 11B).

WARNING

Failure to assemble the T-Pin Ankle Lock System properly could

result in serious injury or death!

Retainer Spring & Cable Loop

FIGURE 11

FIGURE 11A

FIGURE 11B

(continued)

Front Ankle Bar Housing

FIGURE 10