Owner`s manual

Step 3
Install the Rear Ankle Bar Assembly
• With the two ridges of the pre-assembled Heel Cup on the bottom, insert the Rear Ankle Bar
(IA-1113) into the large hole at the back of the Main Shaft (Figure 8).
• Insert the Bolt (F5-1087) from the rear of the Main Shaft to secure the Rear Ankle Bar
(Figure 8), and fasten with the Washer and Nut using the wrenches provided.
• Slide the separate Heel Cup (EP-1054), with the two ridges on the bottom, onto the open
end of the Rear Ankle Bar (Figure 8A).
TIP: To assist with assembly, repeatedly rotate the Heel Cup while pushing it onto the Rear
Ankle Bar.
• Align the pre-drilled holes of the Rubber Plug with the holes in the Rear Ankle Bar. Insert the
Rubber Plug (F5-1056) into the open end of the Rear Ankle Bar (Figure 9).
TIP: You may want to use a rubber mallet to assist with assembly.
• Secure the Rubber Plug with the Screw (H1-1200) using the Screwdriver (F5-1130) provided
(Figure 9A). If the Screw does not tighten easily, you may need to reposition the alignment of
the Rubber Plug.
(continued)
FIGURE 9
FIGURE 9A
1 Ridge
2 Ridges
FIGURE 8
FIGURE 8A