Installation Guide

Installation Instructions for
Aura Vent, Aura Solar Fan & Pop Vent
Retro-Fit Products
Lastly use the four #8 self-taping screws (included in
the box) to attach the vent heads. Screws should be
placed at 12:00, 3:00, 6:00, 9:00.
Now slide your
replacement
head over the
existing collar
Collar
Base
* Before you install, make sure that
the replacement cap is the right size
diameter for your existing base.
Remove the old turbine “head” off the
collar. Leave the collar attached to the
turbine base on the roof.
Lastly, use four #8 self-tapping screws to attach the
vent’s head. Screws should be placed at 12:00, 3:00,
6:00 and 9:00 (Screws not included)