Specifications

Rev. 1.43
User's Guide
21
3
Connectors & jumpers
This chapter will describe all connectors and jumpers on the VSBC-6862.
One of specificity of this board is that the four IP slots occupy most of the board's surface. And it is not
possible to locate connector or jumpers on this area.
In spite of this fact, ACTIS placed the connectors and jumpers in a very straightforward location.
The connectors are numbered upwards: the first connectors for IP, serial ports and Fast Ethernet ports
are in the bottom of the board.
Behind each serial port, are the corresponding termination resistors and jumpers.
Pin numbering convention
The pin numbering is indicated on the 'jumpers and connectors location', on the next page.
- The jumpers have pin 1 indicated by a triangle on the corresponding corner.
For example:
- The connectors and network resistors have pin 1 indicated with a square on the corresponding side.
Example for network resistor:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com