Owner's Manual

18
Actiontec Internet Phone Wizard User Manual
19
Chapter 3 Connecting the Internet Phone Wizard Hardware
5. Insert the other end of the supplied phone cable in the microfilter.
6. Get the phone cable from the telephone and insert one end in the “Phone”
port on the rear panel of the Internet Phone Wizard.
7. Connect the other end of the phone cable to the telephone. The components
should be connected similarly to the figure below:
☞
Note: If the Internet Phone Wizard needs to be disconnected from
the computer for any reason, it must be reconnected to the same
USB port. Connecting the Internet Phone Wizard to a different
USB port may cause problems.
The Internet Phone Wizard is connected in Dual Line mode. Next, go to chapter 4,
“Installing the Internet Phone Wizard Software.”
Connecting to a DSL Filter
If the telephone is connected to the phone line via a wall mount DSL filter, follow
this procedure to connect the Internet Phone Wizard:
1. Get the Internet Phone Wizard from its package.
2. Get the USB cable from the package and insert the small, square end of the
cable in the “USB” port on the rear panel of the Internet Phone Wizard.
3. Insert the other (flat and rectangular) end of the USB cable in a USB port on
the front or back of a computer.
4. Use the supplied phone cable from the telephone and insert it in the “Line”
port of the Internet Phone Wizard.