Owner's Manual

Actiontec Internet Phone Wizard User Manual

Chapter 3 Connecting the Internet Phone Wizard Hardware

7. Insert the other end of the supplied phone cable in a standard phone line out-

let. The components should be connected similarly to the figure below:

☞

Note: If the Internet Phone Wizard needs to be disconnected from

the computer for any reason, it must be reconnected to the same

USB port. Connecting the Internet Phone Wizard to a different

USB port may cause problems.

The Internet Phone Wizard is connected in Dual Line mode. Next, go to chapter 4,

“Installing the Internet Phone Wizard Software.”

Dual Line Connection with DSL Modem

Since DSL modems are connected via phone line (like the Internet Phone Wizard),

there are two ways to connect the Internet Phone Wizard when a DSL modem is pres-

ent: Connecting to a Phone Line Splitter, and Connecting to a DSL Filter. Select the

configuration matching the current computer/DSL set up, and follow the instructions.

Connecting to a Phone Line Splitter

If the telephone is connected to the phone line via a phone line splitter, follow

this procedure to connect the Internet Phone Wizard:

1. Get the Internet Phone Wizard from its package.

2. Get the USB cable from the package and insert the small, square end of the

cable in the “USB” port on the rear panel of the Phone Wizard.

3. Insert the other (flat and rectangular) end of the USB cable in a USB port on

the front or back of a computer.

4. Use the supplied phone cable and insert it in the “Line” port of the Internet

Phone Wizard.