User manual

38
Actiontec USB/Ethernet DSL Modem User Manual
39
Chapter 6 Configuring Advanced Settings
RFC 1483 via Static IP
Select this option if the ISP service is configured to use RFC 1483 using a static
IP address, which causes the IP address and routing information to terminate at
the Modem, as opposed to the IP address and routing information being bridged
to terminate at the computer. This allows the use of the router capabilities for
the Local Area Network (LAN). Enter the IP, subnet mask, and default gateway
addresses provided by the ISP in the appropriate text boxes,.
☞
Note: Contact the ISP if unsure of the proper configuration.
Encapsulation
If the Modem is configured to obtain an IP address through DHCP or to specify a
static IP address, select the appropriate encapsulation option used by the ISP (RFC
1483 Bridged or RFC 1483 Routed).
☞
Note: Contact the ISP if unsure of the proper configuration.
For more information about setting up the Modem to use a static IP address, see
chapter 4, “Setting Up Static IP Addresses,” on page 15.