User's Manual

ManualsBrandsActiontec ManualsElectronicsScreenBeam 960 (Wireless Display Receiver with Bluetooth and WiFi)

http://support.screenbeam.com | http://support.screenbeam.com/ticket

Published September 2018, P/N 0530-0796-001

• Ready to Connect

Ready to ConnectReady to Connect

Ready to Connect indicates the receiver is currently ready for a client device to connect and

project wirelessly. For help on how to connect to your device, visit

http://www.screenbeam.com/setup.

• Receiver name

Receiver nameReceiver name

Receiver name indicates the name that will be shown on the client device’s screen upon

discovering the ScreenBeam receiver.

• Network info

Network infoNetwork info

Network info indicates the status of the network connection.

• Firmware info

Firmware infoFirmware info

Firmware info indicates the current version of the receiver and provides the most accurate

information about the product for technical support. IT admin could verify the version and

perform an update if necessary.

SET

SETSET

SETUP

UP UP

UP SCREENBEAM

SCREENBEAM SCREENBEAM

SCREENBEAM FOR

FOR FOR

FOR NETWORK CONNECTION

NETWORK CONNECTIONNETWORK CONNECTION

NETWORK CONNECTION

ScreenBeam receiver requires network connection for couple various functionalities; Wireless display

over LAN and Central Management. You can connect the ScreenBeam receiver to the network via either

wired or Wi-Fi connection.

• Wired connection

Wired connectionWired connection

Wired connection

If the network connection for ScreenBeam receiver provides a DHCP IP address, the Ready to

Connect screen shall display a valid IP address under network status.

• Wi

WiWi

Wi-

-Fi connection

Fi connectionFi connection

Fi connection

or Static IP address

or Static IP address or Static IP address

or Static IP address

This requires additional steps to configure the receiver with the proper network information. The

detailed instructions can be found online at http://support.screenbeam.com. For initial testing

purpose, we recommend using wired network connection with DHCP.

D D

D ACCESS

ACCESSACCESS

ACCESS

SCREENBEA

SCREENBEASCREENBEA

SCREENBEAM RECEIVE

M RECEIVEM RECEIVE

M RECEIVER FOR CONFIGURATION

R FOR CONFIGURATIONR FOR CONFIGURATION

R FOR CONFIGURATION

You can configure ScreenBeam 960 receiver by accessing the receiver web management console or by

using the ScreenBeam CMS software. If the ScreenBeam receiver is being managed by ScreenBeam CMS,

then you may skip this section.

There are a couple of options to access the ScreenBeam receiver’s management console:

• Option 1

Option 1 Option 1

Option 1 -

Access

AccessAccess

Access

the receiver via local network

the receiver via local networkthe receiver via local network

the receiver via local network

o Verify the ScreenBeam receiver has obtained a valid IP address if it’s connected to the

network.

o Connect a laptop or PC to the same network as the ScreenBeam receiver

o Open a browser and enter the IP address of the ScreenBeam receiver into the browser’s

address text box (i.e. http://x.x.x.x)

ScreenBeam

960 receiver

is now ready to connect for Wi

Fi Miracast client devices via P2P

Go ahead

and connect from your Windows 10/8.1 Miracast device. If you need guidance on how to connect

from a Miracast device, go to http://www.screenbeam.com/setup.

For MacOS, iOS, and Win7 client devices support; proceed to the next section for instructions on

configuring ScreenBeam receiver for wireless display over LAN.