User's Manual

http://support.screenbeam.com | http://support.screenbeam.com/ticket

Published September 2018, P/N 0530-0796-001

CONNECT

CONNECTCONNECT

CONNECT

SCREENBEAM

SCREENBEAM SCREENBEAM

SCREENBEAM RECEIVER TO

RECEIVER TO RECEIVER TO

RECEIVER TO A

A A

A DISPLAY

DISPLAYDISPLAY

DISPLAY

1. Place the receiver next to a display of choice.

2. Using the provided HDMI cable, connect one end of the cable to the receiver’s HDMI port and the

other end to the HDMI port of your display.

3. (Optional) If the display is supports interactive touch, you may connect the USB Type-B to Type-A

“Touch” cable to the ScreenBeam receiver’s USB port.

4. Connect one end of the receiver’s power supply to the receiver’s power port, and the other end

to an electrical wall outlet.

5. Connect an ethernet cable to the ScreenBeam receiver’s ethernet port and connect the other

end to your network switch/router with DHCP IP.

Note

NoteNote

Note: This step is required for wireless display over LAN function OR to access the management

console via the network.

6. Turn on the TV and switch to the HDMI input to which the receiver is connected to.

7. Wait about 30 seconds, then verify the TV displays the Ready to Connect

Ready to ConnectReady to Connect

Ready to Connect screen.

UNDERSTANDING

UNDERSTANDINGUNDERSTANDING

UNDERSTANDING

THE

THE THE

THE READY TO CONNECT SCREEN

READY TO CONNECT SCREENREADY TO CONNECT SCREEN

READY TO CONNECT SCREEN

Figure 2 - Ready to Connect screen

Figure 1 Receiver connection guide