Owner's Manual
Table Of Contents
- Introduction
- Connecting the Router
- Configuring My Network Settings
- Using Network Connections
- Configuring the Router’s Security
- Using Parental Controls
- Using Advanced Settings
- Firmware Upgrade
- Firmware Restore
- Configuration File
- System Settings
- Date and Time
- Scheduler Rules
- Routing
- IP Address Distribution
- Diagnostics
- Restoring Default Settings
- Reboot the Router
- MAC Cloning
- ARP (Address Resolution Protocol) Table
- Users
- QoS
- Local Administration
- Remote Administration
- Dynamic DNS
- DNS Server
- Network Objects
- Universal Plug and Play (UPnP)
- Protocols
- Monitoring the Router
- Troubleshooting
- Quality of Service
- Specifications
- Notices
- Limited Warranty
40
Actiontec Broadband Router User Manual
41
Chapter 4 Using Network Connections
Configuring the WAN PPPoE Connection
Click Settings in the WAN PPPoE Properties screen to generate the “Configure
WAN PPPoE” screen.
General
The top part of the Configure WAN PPPoE screen displays general communica-
tion parameters. Actiontec recommends not changing the default values in this
section unless familiar with networking concepts.
Status Displays the connection status of the WAN PPPoE connection. (“Down,”
“Disabled,” “Connected,” etc.)
When should this rule occur? Displays when the rule is active. To schedule rules,
see “Advanced Settings” chapter.