Owner's Manual
Table Of Contents
- Introduction
- Connecting the Router
- Configuring My Network Settings
- Using Network Connections
- Configuring the Router’s Security
- Using Parental Controls
- Using Advanced Settings
- Firmware Upgrade
- Firmware Restore
- Configuration File
- System Settings
- Date and Time
- Scheduler Rules
- Routing
- IP Address Distribution
- Diagnostics
- Restoring Default Settings
- Reboot the Router
- MAC Cloning
- ARP (Address Resolution Protocol) Table
- Users
- QoS
- Local Administration
- Remote Administration
- Dynamic DNS
- DNS Server
- Network Objects
- Universal Plug and Play (UPnP)
- Protocols
- Monitoring the Router
- Troubleshooting
- Quality of Service
- Specifications
- Notices
- Limited Warranty

139
Notices
Regulatory Compliance Notices
Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by implementing one or more of the following measures:
s Reorient or relocate the receiving antenna;
s Increase the separation between the equipment and receiver;
s Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected;
s Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made
to this device that are not expressly approved by Actiontec Electronics, Inc., may
void the user’s authority to operate the equipment.
Declaration of conformity for products marked with the FCC logo – United States
only.
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful interference;