User`s guide

Index
Page 84
First card services client
already registered.
The Super Client driver must be
the first Card Services client
driver loaded, and it must be
loaded only once.
Flash card programming
algorithm not supported.
CardTalk does not support the
Flash card identified by
Flash
card
.
Flash card programming this
card not supported.
CardTalk does not support the
Flash card identified by
Flash
card.
Getdevparam failed -- probably
wrong DOS version.
You may be using an older
version of MS-DOS, or you may
have a mismatch among the
revision levels of the CardTalk
software components.
Insufficient disk space.
The file copier cannot copy the
files because the target disk or
card does not have enough space
to hold the files.
No card in drive.
Put a card in the socket.
No room on card.
Delete files from the card to
make room and copy the file(s)
again. In the case of a FAT/Flash
formatted card, you may have to
erase and reprogram the card. In
the case of an FFS1 formatted
card, even when files are erased,
the space is not reclaimed as it is
with FFS2, so you may have to
erase the card to recover the
space.
No room on disk.
Delete files from the card to
make room and copy the file(s)
again.
No socket Services BIOS
sockets found.
Refer to the section in this
chapter titled Initialization
Problems.