User`s guide

Introduction
Page 8
Install the Card Reader
Prepare the Card Socket Module
1. Read the License Agreement.
2. Turn the computer's power off, leave the power cord plugged in to
ground the unit, and remove its cover.
3. If the bay you’re using is a 5.25” bay, install the rails and side
brackets on the Card Socket Module (optional equipment).
Install the Card Socket Module
WARNING
Avoid Crossed Ribbon Cables
To alleviate confusion, the ribbon cable is
constructed so that the ends that are tied together
should be connected to the drive module. The loose
end of the ribbon cable should be connected to the
ISA card. Both ends are keyed accordingly to enable
only one correct way to connect them.
1. Touch a bare metal portion of your PC's chassis to discharge static
electrical buildup before you remove the ISA bus board and Card
Socket from their protective covers.
2. Connect the ends of the ribbon cables labeled DRIVE to their
respective connectors on the Card Socket Module.
3. Install the Card Socket Module in the PC drive bay and attach it to
the chassis with at least three screws. Two screws must connect
metal to metal for grounding purposes.
4. Connect a spare device power cable to the card socket module. You
may need to use the enclosed splitter.