User`s guide

Introduction
Page 6
Quick Start
This preface is designed to help experienced users get going quickly. It
summarizes what you need to do to install the Card Reader in your
computer.
WARNING
Assumptions
If you’re not sure about the assumptions in this
Quick Start or would like illustrations to assist you
with the installation process, refer to Chapter 2,
Installing the Hardware.
Assumptions
These procedures assume:
• the default I/O address of 240h will not conflict with any other
devices installed in your system (such as a sound card)
• your computer has a spare internal power cable
Requirements
• IBM compatible computer with a minimum 386Sx processor
• an empty 16-bit ISA bus slot running at approximately 8 Mhz
• an empty drive bay
• at least 1 Mbyte of RAM and 500 Kbytes of free disk space
• DOS 3.2 or later
• Windows 3.1 (or later) or Windows for Workgroups 3.1 (or later)