User`s guide

Installing the Software
PC-250, PC-260, and PC-300 User’s Guide Page 41
NOTE
Segment Address
These are the high-order 16 bits of the 20-bit
address, the segment address in x86 terms.
To accept the default starting memory address D000, press Enter.
To request a different address, type a hexadecimal number between
C000 and E000 at the Enter the Memory Window's Starting
Address: prompt and press Enter.
5. INSTALL displays:
Enter the Memory Window’s Ending Address.
Accept the default ending memory address of DFFF if you accepted
the default starting address by pressing Enter. If you entered
another starting address, enter a higher ending address between
CFFF and EFFF at the Enter the Memory Window's Ending
Address: prompt and press Enter.
6. INSTALL advises you to manually exclude the memory range you
defined if you are using a memory manager other than EMM386,
386MAX or QEMM386. Refer to your memory manager
documentation for instructions.
Press any key to continue with the installation.
Completing Installation
INSTALL displays a list of the settings you have selected and gives you
a chance to change any of them. The following is a sample custom
installation listing:
The Card Reader with Microsoft’s Flash File System.
Destination directory C:\PCMCIA.
The drive is installed at I/O address 340.
The Card Insertion Annunciator is inactive.
Modem cards will appear as COM4 using IRQ9.
The user selectable I/O window is 320 - 32F.
The user selectable memory window is D000 - D7FF.
ATA drives will use address 180.