User`s guide

Installing the Software
Page 34
Run INSTALL
1. Set the write-protect tab on the distribution diskette.
2. Insert the distribution diskette into a 3.5” diskette drive.
3. At the MS-DOS system prompt, type:
drive:install
and press Enter.
NOTE
drive : identifies the floppy drive that contains the
installation diskette
INSTALL displays:
One moment please, checking hardware . . .
while it locates and identifies the Card Reader installed in your
system. This may take a minute or two.
4. At any screen, press the key named on the screen to continue with
the installation or press Esc to quit installation.
After displaying the title screen, INSTALL asks whether you wish
to perform an Express or Custom Installation. An express
installation requires that you install the hardware before you install
the software and that the hardware be configured correctly.
5. To select an express installation, press Enter. If you know you need
to change any of the default settings, press ↓ to move the highlight
to Custom and press Enter.
Express Installation
An express installation uses the default settings and automatically
updates your configuration files. The following is a typical default list:
The Card Reader with Microsoft’s Flash File System.
Destination directory C:\CARDTALK
The drive is installed at I/O address 240.