User`s guide

Installing the Hardware
Page 28
Install the Board
WARNING
Avoid Crossed Cables
Do not cross the cables. The cable ends labeled ISA
Card must be connected to the respective
connectors labeled ISA Card. The cable ends
labeled Drive must be connected to the respective
connectors labeled Drive.
A
B
Connecting the Ribbon Cables to the ISA Bus Board
1. Align the red stripe on the cable whose end is labeled ISA Card
with pin 1 of the board connector labeled ISA Card, and connect
the cable.
2. Align the red stripe on the cable whose end is labeled Drive with
pin 1 of the board connector labeled Drive, and connect the cable.