Owner's Manual
Connecting the FiOS Router
2.3 Conguring the FiOS Router
2
24
© 2010 Verizon. All Rights Reserved.
Make sure the corresponding Ethernet LAN light on the front of the FiOS 3.
Router glows steadily green.
Repeat these steps for each computer to be connected to the FiOS Router 4.
via Ethernet.
Wireless
Make sure each computer to be connected wirelessly has built-in wireless or 1.
an attached wireless adapter.
Make sure the computer uses the same ESSID and WEP key as the FiOS 2.
Router by launching the computer’s wireless application
Enter the ESSID and WEP key found on the sticker on the bottom of the 3.
FiOS Router in the computer’s wireless settings and click Save. Make sure to
configure the computer to use 64/40-bit WEP encryption.
Make sure the changes were implemented by surfing the Internet from 4.
the computer.
Repeat these steps for every other computer to be connected to the 5.
FiOS Router wirelessly.
Coaxial
Make sure all set top boxes are turned off.1.
Disconnect any adapter currently connected to the coaxial jack in the room 2.
where the FiOS Router is.
Connect one end of the coaxial cable to the coaxial wall jack, and the other 3.
end to the red Coax port on the back of the FiOS Router.
Power up the set top box.4.
Make sure the Coax LAN light on the front of the FiOS Router glows steadily 5.
green. This may take a few minutes. When it does, the set top box is
connected to the FiOS Router.