Quick Start Manual

Note: An Ethernet port looks similar to a phone port but is slightly larger.

Connect the Adapter to a PC or Modem/Router

Step

1 Get one MegaPlug AV

200 Mbps Ethernet Adapter from

the box.

Step

5 Plug the other end of the

Ethernet Cable into an OPEN

Ethernet Port on your Modem or

Router.

Step

4 Plug the MegaPlug

Adapter into a Power Outlet.

Do NOT

plug the Adapter into a

power strip or wall outlet that uses

surge protection as the Adapter

may not work.

Flip this Quick Start Guide over to continue

Step

2 Get one Ethernet Cable.

Step

3 Plug one end of the

Ethernet Cable into the Ethernet

Port on the bottom of the

MegaPlug Adapter.

Step

6 Repeat Steps 1-5 for a

computer or an Internet device.

Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA)

Broadband

Router

PAGE 1
Connect the Adapter to a PC or Modem/Router 4 Step 1 Get one MegaPlug AV Step 200 Mbps Ethernet Adapter from the box. 2 Get one Ethernet Cable. Step Plug the MegaPlug Adapter into a Power Outlet. Do NOT plug the Adapter into a power strip or wall outlet that uses surge protection as the Adapter may not work. 5 Plug the other end of the Step Broadband Router Ethernet Cable into an OPEN Ethernet Port on your Modem or Router.
PAGE 2
7 Step Make sure that the Link light on each Adapter turns SOLID Green. Congratulations! You have successfully installed both MegaPlug AV 200 Mbps Ethernet Adapters. These adapters ship with a generic encryption key. If you would like to change the key, refer to our website for further instructions. If you require additional adapters for additonal computers/devices, they may be added by following the same steps in this guide.