Quick Start Manual

Quick Start Guide
Connect the Adapter to a Device
Install the Configuration Utility
B
A
This Quick Start Guide will walk you through the
easy steps to install and set up your MegaPlug™
85 Mbps Ethernet Adapter.During this process,we
will show you how to:
You will need the following items:
•
MegaPlug™ 85 Mbps
Ethernet Adapter
•
Gray Ethernet Cable
•
Installation CD
(Note: Each device that needs to
communicate using the power will
need its own MegaPlug adapter)
NEXT
Part No:0530-0516-000 QS796/1005
Questions? Call 1-888-436-0657 (USA)
Model# HPE100T
Congratulations! You have successfully installed the MegaPlug
85 Mbps Ethernet Adapter.You can find the Configuration Utility
by going to
Start ➔ Programs ➔ Actiontec MegaPlug.
Note: If the screen above does not appear,click Start on the taskbar and then
select Run. Type d:/setup (or e:/setup,depending on the drive letter of your CD-
ROM drive),then click OK..
Step
2 When the “Welcome”
screen appears,click
Next.
Step
3 When the “Choose
Destination Location”screen
appears,click
Next.
Step
4 Then click Finish.