User's Manual

Wireless Networking

4.3 Connecting a Wireless Client

To connect a wireless client to the Gateway:

Note: The following procedure assumes the Gateway’s default wireless

settings are intact. If they have been changed, use the new SSID and wireless

security settings.

In the wireless client’s configuration interface, enter the Gateway’s SSID 1.

(found on a sticker on the bottom of the Gateway’s case) in the appropriate

text box or field (this varies depending on the wireless client’s manufacturer).

Enter the Gateway’s WPA key (also found on the sticker on the bottom of the 2.

Router’s case) in the wireless client’s configuration interface.

Save the changes and exit the wireless client’s configuration interface. The 3.

client should now detect and join the Gateway’s wireless network. If not,

check the wireless client’s documentation, or contact its manufacturer.