User guide

Actiontec GT724WG Router

1-888-850-5915

Technical Support

103948/3-11/6960

Setup and User Guide

Windows 2000:

1. Select Start, then Settings, and then Control Panel.

2. Select Network and Dialup Connections.

3. Right-click Local Area Connection, then select Properties.

4. Highlight (do not uncheck) Internet Protocol TCP/IP.

5. Select Properties.

6. Set the computer to Use the following IP Address.

7. Use the information from your welcome letter to complete the conﬁguration ﬁelds (IP Address, Subnet Mask,

Default Gateway, DNS).

Mac OS X:

1. Select the Apple menu, then select System Preferences.

2. Select Network.

3. On the Show dropdown box, select Built-In Ethernet.

4. On the TCP/IP tab,make certain the Conﬁgure IPv4 dropdown box is set to Manually.

5. Using the information from your welcome letter, set the following:

• IP Address: One of the LAN Usable IPs

• Subnet Mask: LAN Subnet Mask

• Default Gateway: LAN Default Gateway

• DNS Servers: DNS Primary & Secondary Servers

6. When asked if you want to apply conﬁguration changes, select Apply.

Mac OS 8/9:

1. Select the Apple menu, then select Control Panels, and select TCP/IP.

2. On the Connect via dropdown box, select Ethernet.

3. On the Conﬁgure dropdown box, select Manually.

4. Using the information from your welcome letter, set the following:

• IP Address: Any one of the LAN Usable IPs

• Subnet Mask: LAN Subnet Mask

• Router Address: LAN Default Gateway.

• Name Server Addr.: DNS Primary & Secondary Servers

5. Click Close.

6. When asked if you want to save changes to the conﬁguration, select Save.

After conﬁguring your computer, reboot your router by turning it off and then back on. Finally, open a browser

and verify that you can access the Internet. If you cannot, please contact our Internet Technical Support team.