Specifications
5
for certain notebooks. Try Example A: first and use Example B: if your re-
sults are not satisfactory. Add a line to your config.sys file as follows:
Example A: device=c:\dos\emm386.exe noems x=d000-dfff
Example B: device=c:\dos\emm386.exe noems x=c800-c8ff x=d000-dfff
Remember, the Point Enabler should not be used with any Card and Socket
Services software. It is meant to be used in a computer that does not have its
own PCMCIA Card and Socket Services software and is for a DOS/Win-
dows 3.1X environment only. It should not be used if you have a Cardbus
capable notebook or are running Windows 95/98 or Windows NT.
For WINDOWS 95/98 INSTALLATION
Since a fax/modem is usually the first accessory purchased for a notebook
computer, it is a good idea to check that the computers PCMCIA controller
has been initialized and properly configured for Windows 95/98. Performing
this simple procedure will eliminate the major cause of installation difficul-
ties.
In Windows 95/98, go to: Start-Settings-Control Panel and double-click
the PC Card icon. A properly installed PCMCIA controller will show the
screen below.
If the New Hardware Found panel appears, your computers PCMCIA Ports
have not been configured. Follow the installation instructions on the screen.
You can also read your computers Users Guide for additional instructions on
configuring your PCMCIA ports for Windows 95/98.